Eeger Beever™ 1415 Track Brush Chipper

Standard equipment

• Caterpillar 303.5 Track Undercarriage with 300mm rubber tracks, 4.84 PSI ground pressure, low speed travel range of 90 FPM (1.0 MPH) and high speed travel range of 160 FPM (1.8 MPH)
• Wireless remote control operation with tethered back-up system that controls the track, feed and yoke functions, along with the emergency engine stop
• Morbark orange urethane paint system
• Infeed with rigid tray and control handle to actuate feed wheels and dual safety pull cables
• Dual horizontal feed wheel compression system with hydraulic lift assist, spring assisted down pressure and manually applied hydraulic down pressure at the valve handle
• Reversing automatic feed system
• 21-3/8” diameter x 14-1/2" wide staggered knife pocket drum with two (2) dual-edged chipper knives and dual sided chambered air impeller system
• 24-1/2-gallon lockable fuel tank with drain plug, sight gauge and shut-off valve
• 19-gallon lockable hydraulic reservoir with sight gauge, drain plug and clean-out cover
• Live hydraulics; ball valve, pump, motor and control valve
• Hydraulic swivel discharge chute with 360° rotation, turnbuckle height adjustment, bottom clean-out door and adjustable flipper
• 4” x 2” tubular steel frame with cross bracing for additional structural rigidity
• Steel guard enclosing valve bank
• Lockable steel tool box and battery box combination with 8D, 1400CCA battery
• Registration and operator guide holder
• Complete set of manuals including: Safety and Operator’s, Parts Manual with electronic back-up, which also includes a Safety Video and OEM component manuals. Also included is an engine manual if applicable along with start-up paperwork
• Enclosed engine with gauge panel, radiator fines screen and slide rails for belt adjustment
• Caterpillar C3.4F, 74-HP, Tier 4F diesel engine with automotive clutch and block heater (limited availability)